Epoxy floors · Fountain Hills, AZ
Fountain Hills epoxy flooring company for garage bays
Fountain Hills garages sit on ground that rises and falls, and where one is cut into a slope, a wall holds the uphill side and the driveway runs down to the door. Water reaches that door first. Tell us the layout and the square footage, and someone from our team calls you back to plan your Fountain Hills epoxy flooring project.
Good to know
What a hillside garage floor needs
The town reads around 1,634 ft at Town Hall on a USGS 3DEP point query, and that figure describes one spot. Elevation is not the issue here; grade is. The median year built is about 1994, with about 58 percent of housing units built between 1980 and 1999, per ACS 2020-2024 5-year estimates via Census Reporter, so most of the housing is a quarter century old or more and the slabs have had time to settle, crack and take water at a door. The ZIP codes here are 85268 and 85269, both with Fountain Hills as the USPS primary city.
- A grade check at the door before a system is named, because runoff matters as much as moisture in the slab.
- A flake or solid build at 20 to 30 mil for a working bay, with a UV-stable topcoat on the sunny end.
- Crack and control joint repair that lets the slab move without splitting the film.
- Spalls at the apron cut back to sound concrete, since a feathered edge can lift under a tire.
Systems
The floors that fit Fountain Hills buildings
About 66 percent of the housing units here are detached single-family homes, according to the same ACS release, and the residential work is a garage bay, a casita floor and a workshop. Commercial space is small. The Town of Fountain Hills names the Shea Corridor as a target area for redevelopment and revitalization, with Four Peaks Plaza inside it, alongside Downtown, Saguaro and Fountain Hills Boulevard/Glenbrook in its August 2024 economic development status report. A restaurant floor on Shea takes kitchen water and foot traffic, and a garage up a hill takes tires and afternoon sun.
Signs
4 signs a Fountain Hills floor is going
Water marks run inward from the garage door. A driveway on grade can send monsoon runoff across the slab, and a coating over concrete that stays damp can lift at the threshold.
A crack follows the retaining wall. A slab poured against a wall that moves with the hill can crack along the same line, and the film can split over it.
The sunny end has gone pale. Sun through an open door breaks down a film without UV protection, and the fade stops at the shade line.
The floor sounds hollow under a tap. A hollow note can mean the coating has come off the slab, and another coat over it is unlikely to bring it back.
3 steps
How the work runs
The garage gets looked at with the driveway in view. Where water runs, where the slab meets the wall, how the car comes in.
Grinding opens the concrete, cracks and spalls get filled, a moisture probe goes in, and the apron edge gets cut back to sound material.
Base, broadcast and topcoat, then the cure clock. Light foot traffic at 12 hours, everyday use at 24 hours, garage contents at 48 hours and a vehicle at 96 hours in warm conditions, per a garage flooring company's guide.
Costs
What epoxy flooring costs in Fountain Hills
The published rate is $4 to $10 per sq ft installed (HomeGuide (opens in a new tab)), and a 2-car garage runs $1,600 to $5,800. Family Handyman (opens in a new tab) lists a single garage, professionally installed, at $1,594 to $3,330, and a 2-car at $1,080 to $4,320 with labor included. The 2 sets can differ because the builds differ: a single coat with no broadcast is not a flake build with a polyaspartic topcoat, and a hillside bay with a stepped apron can carry detail a flat lot does not.
| Scope | Published range | Source |
|---|---|---|
| Epoxy, installed | $4 to $10 per sq ft | HomeGuide |
| 2-car garage | $1,600 to $5,800 | HomeGuide |
| Single garage, installed | $1,594 to $3,330 | Family Handyman |
| 2-car, labor included | $1,080 to $4,320 | Family Handyman |
Published ranges, not a quote.
3 questions
Questions from Fountain Hills owners
Still have a question? Call (747) 243-2089 and describe the floor.
Does the slope rule change what goes on the floor?
The slope rule shapes the lot rather than the coating. The Town of Fountain Hills Subdivision Ordinance, section 5.04, limits hillside disturbance in a subdivision to 40 percent of areas with slopes of 20 percent or more (Town Code (opens in a new tab)). At the door that means a garage cut into a hill, a wall holding the uphill side and a driveway on grade, so drainage gets checked before the slab does.
How long is the garage out of use?
Certain polyaspartic stages can cure in as little as 20 to 60 minutes, and in warm conditions light foot traffic comes at 12 hours, everyday use at 24 hours, garage contents at 48 hours and vehicle traffic at 96 hours, per a garage flooring company's guide. Prep sets the schedule: grinding, filling and testing all happen before that clock starts.
What does a garage bay cost here?
A 2-car bay runs $1,600 to $5,800 at the published HomeGuide range, and a single garage $1,594 to $3,330 from Family Handyman. A casita floor is priced at $4 to $10 per sq ft installed (HomeGuide).
